I usually did a 45 because that's easier but not necessary, could be any angle you want. Your plunge in will be a little tricky because it takes a moment for the slide to start moving but since this is not a real thread probaly won't matter. You only want to read the lead and the modal G33 once at the beginning of the pass. Position the tool in X off the part surface at the Z start point, then first threading block a G33 with a Z and an X and your K lead, then next block no G33, just the Z departure, no lead, then next block again no G33 but an X and a Z departure and no lead, then back to the start point in rapid. ![]() On an American control that's easy, but takes three blocks per pass.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |